Key Fob Case Replacement 5 Button for Chevy Cruze Camaro Impala Equinox GMC Terrain Buick Regal Lacrosse 2010 2011 2012 2013 2014 2015 2016 2017 Keyless Entry Remote Control Car Key Fob Shell - 2 Pack

These worked great for me! I had 2 fobs. One in ok shape and the other in pieces after a previous owner tried to change the battery I suspect. So I started with the one in pieces. Watch the video to get a basic idea of assembly. I used the key, spring, & button from the original fob. First place the silver battery terminal in place on the edge of the battery compartment. It sits behind two small tabs. Place the circuit board with the buttons into the button half of the case. It should fall into place with an alignment tab into a slot on the circuit board. Set it aside. Take your key, spring, & button. Make sure the button is properly aligned with the slots in the key. When it protrudes the most it is right, otherwise it’ll barely stick out. Now the fun part. Place the key,button, spring assembly onto the back half of the fob, wind it once counter clockwise, and press the key down into the closed position. If it doesn’t lay flat your button isn’t aligned properly. Then holding that in place take the other half of the case, align them together, and carefully snap them together. It may take a few tries or extra hand. Now try the key button. If the key doesn’t flip open easily, try two turns on the spring. Install a new battery and the cover should easily snap into place. Now try the remote! Getting into the other remote wasn’t easy. I used a flat tip screwdriver in the slots at the top of the remote where the key attaches. I twisted the tip to break the glued halves apart at the top and just enough on the two sides to get them pried just far enough for the circuit board to slip out. DON’T get in a hurry and damage the board. These do work and are a great bargain at this price. The buttons are a bit stiff due to being a flexible plastic instead of rubber but not bad at all in my opinion.

Great product.. mine were damaged.. the buttons were disintegrated.. and didn't work right. These have a solid quality feel. They work great. I transferred my already cut key tab into the new fob. No need for programming, these were fob shells. Highly recommend

it gets the job done. minus one star because the flip doesn’t work anymore but other than that it’s pretty sturdy and easy to open up and put the mechanics inside

Super simple to set up and install. Instructions are easy, tool included works well, keychain is a bonus. These are just a case, you swap your board and away you go.

Hard to get apart and the instruction video sucks. It would be nice to have written instructions to go with the video. The key fob should come disassembled so you don't have to pull it apart and risk damaging it. Also, it didn't work for the trunk button on a Chevy Cruze 2013. The piece looked like it aligned with where the trunk button goes but it didn't and I couldn't tell until I tried to use it. Wasted so much time taking the old key apart and trying to put this one together. When I searched for the replacement I used my car info to get products that would fit. Everything came up with this version of the key so I figured it was just a generic style. None of the single trunk button fobs even came up when I was searching which made me think they just sold this kind. I don't understand why I would be recommended this product by Amazon after using the license plate number to match my car exactly. Not happy

Did not work for 2012 chevy cruze. Otherwise is good quality.

My Granddaughter put it all together in 20 minutes while watching the video provided and it works perfectly! Thank you!

This was not a super clean replacement initially. My old key would not fit the new fob. The little spring was not fun! I finally disassembled the key by driving out the pin and reassembling it to the holder/pivot on the new fob. After that I was able to reassemble the new fob and it worked perfectly.

easy swap of circut board from one to another

Cumple con su funcion

Muy buenos materiales por el precio

Make sure you pay attention to what part goes where. Great product, easy to assemble and reassemble. I didn’t even need to program the key, that’s how excellent it works. Much better than paying a dealer for a new fob!

As described. Little hard working with the spring inside. Couldn’t get the spring back on. Still works just doesn’t close anymore.