Turn Signal Light

Awesome light. I like the startup sequence. I recommend hotgluing where the wire comes out of the light fixture because the wires are super thin and exposed there. The adhesive sucks, so I used gorilla tape and it sticks fine to my electric skateboard trucks. Refer to video

Bought these for our polaris ranger. They work great. Wires are tiny but work great. Works great with turn signal harness. Turn signal lights are great as well.

I bought these to replace another manufacturer's third set of turn signals. I installed them on my 27 T Bucket. It took me an entire day to get the correct wiring combination. The installation instructions are three very short sentences and leave much to be desired. These signals are very bright and work as advertised. I especially like the daytime running lights. My old set had this feature and it pays to be seen. Because these are LED lamps, they don't let your voltage go below 10.5 VDC. They will quit working when the voltage gets that low. The adhesive was just adequate. I added stronger adhesive to be sure they don't come off driving down the road. They seem to be sturdy but time will tell. The wire is much too small and hard to work with. You have to be very careful when stripping the insulation. Do not use crimp connectors. I used the connectors with solder in the middle and shrinkwrap to insulate

aporta super buena iluminación en oscuridad. excelente para evitar accidentes nocturnos

Several issues with this product: 1) the wire leads are both oriented for the same side. If you flip one over the wires come out the top instead of the bottom. How hard would it be to provide a "left" and "right" drilling for the wire hole. (See picture) 2) half the LEDs don't work on the one I test fit. You can see where the LED strip has bubbled up inside the plastic housing so poorly assembled. (See video) 3) the silicone sealant at the ends is not water tight so even if installed I wouldn't expect them to last long at all. Great concept but VERY poor build and execution. Invest in a higher quality product before you waste time wiring these up.

Bright and nice looking.. only problem is the wire its too thin.

Leds out of the box were got and miss brightness after applying 12 volts. The wires are integrated into the plastics both facing the same direction so they didnt think about mounting opposite facing for turn signals when made. Cant speak of longevity as they were too cheap for me to want to install, might be best for trailer lighting. They do however do exactly as advertised with turn led switchbacks. Easy wiring just really cheap and not very good led's

They are easy to instal and are bright . Before installing check to see which way the amber flashes.

Worked amazing one light had a broken seal over winter and the seller sent a full refund for replacement! Great communication