UniBond Sealant Remover

I was removing old, horrible silicone sealant from around the lid of a top-loading boat fridge. It was a really yucky, horrible job, and the old sealant was hard, dried-up and with all sorts of embedded gunk and mess (previous owners' gunk and mess, to make it even worse, not ours). I was getting fed up with scraping at the old sealant despite having a good scraper tool that worked well, so I decided to give this product a try. It's true that it is 'thick gel', which means it does not run. But it also means it's a little hard to spread, although it's perfectly do-able, albeit a little messy. Better that than a runny product though, as it does not end up going everywhere. I left it on for a bit longer than it says on the instruction and it made it so much easier to get it off with a scraper tool. It also ended up cleaning the stains (rust stains?) around the lid, which was an unexpected bonus. It did not stink as much as I was expecting it to, either. Overall, it worked well. I needed a bit of patience to allow enough time for it to work, but I'm very happy with the result. I recommend that you make sure to wipe it off properly before applying the new sealant, or it may not stick as well as it should.

This works really well as long as you spend time getting the majority of the sealant off beforehand using a scraper or blade. Once you've done this it is great for removing any residue. Note there isn't much of the stuff - there was enough to do two sides of my shower tray with a bit left over. I reckon there's enough to go down a short and long edge of a bath. I'm giving 4 stars because they don't make it obvious that you'll need to do a lot of work scraping before you can use this effectively.

A must-have for any sealant job! I was dreading the tedious task of removing old, stubborn silicone, but this product made it incredibly easy. The gel formula softened the hardened sealant in about 3 hours, allowing me to scrape it away cleanly without any fuss or damage to my tiles. It saved me so much time and effort, leaving a perfectly prepped surface for the new sealant. Highly recommend!

It wasn't easy to apply. It comes out as a jelly which just moves around instead of sitting on top of the sealant. A thick paint would be easier to apply. It probably did help remove sealant but brute force did most of the job.

Excellent product. Bit more expensive than other products but well worth the extra and goes further than one anticipates. Used to remove silicon off various places in bathroom following a refit.

Good but i had to use WD40 as well with it on a concrete wall with pebble dash, very difficult,somebody had filled the cracks with silicone sealant and paint came off the sealand

Works but takes a while

Leave it in old sealent for some time. It made it very easy to scrape it away.

Worked perfectly

Il prodotto è P E R F E T T O, nel senso che fa quanto promesso: applicato su silicone trasparente indurito, e lasciato "a lavorare" per una notte, lo trasforma in una specie di pasta facilmente removibile con una spatola. Prima di qs prodotto ne avevo provati altri che, purtroppo, non funzionavano affatto. Ho rimesso a posto un lavandino sul quale l'idraulico aveva fatto un bel pasticcio col silicone. Ripulito e rifatto il lavoro, questa volta per bene. Lo consiglio vivamente

É veramente efficace, anche su un silicone vecchio di anni fa,e fra l'altro posizionato (il silicone)in maniera indegna dal mio compagno pasticcione. L'unica pecca é che il tubetto (80 ml) é piccolo, io ne ho comprati 3 x un box doccia e mi faccio arrivare il quarto x togliere via gli ultimi pezzettini rimasti, però considerando il costo dei formati più grossi, forse ho risparmiato?!?!

Mi aspettavo un quantitativo sufficiente per il silicone di un bordo vasca su tre lati, ma non è stato così. Prodotto costoso. Metto tre stelle, perchè malgrado questi limiti il prodotto è efficacissimo. Più di altri provati. Quindi magari si potrebbe usare in caso di piccole superfici.

Prodotto ottimo, testato su una vasca da bagno in acrilico lucido e su vetro. Si applica ricoprendo bene il silicone, si lascia agire per qualche ora e poi si pulisce con uno straccio; del silicone non rimane nessuna traccia.