ONLINE LED STORE TRUE MODS 4pc 6" Red Oval Trailer Tail Light Kit [DOT FMVSS 108] [SAE S2TSI6P2] [Grommet & Plug] [IP67 Waterproof] [Stop Turn Tail] Trailer Brake Lights for Boat Trailer RV Trucks

Don't know what the deal is, but I bought new versions of the same lights I already had and this is what the new ones are doing in the center. Again the one on the left and right are the exact same brand and same part number... I did the old switcheroo to check and of course the wiring was right. These are going back...

These lights look great, but they are quite a bit smaller than the original lights. The gasket that comes with these lights are so small they will simply fall out. Had to use my old gaskets. Even then the lights didn’t fit tight like they should have. Ended up applying some silicone around them so they wouldn’t fall out going down the road.

I had to splice the wiring together because the plugs were different between the two, but that's easy! The wiring pigtail comes with the light unit but is not installed. The pin receptacles on the light back are covered with a piece of tape because the female pins are already filled with 'bulb grease' and the tape holds it in. My guess is for boat trailers, but I'm not going to argue. Wire the pigtails, remove the tape, plug the pigtail into the light, insert the gasket into the hole, pop in the new light. Done!

For the money you can’t beat these lights, I used my existing wiring and grommets. Slid the light in, plugged in & done. Installed 2 driver side brake/turn and two reverse lights in less than 10 minutes. If your shopping for affordable LED’s that are easy to install I’m sure you’ll be happy with these.

Fits well, look nice and lighrs up awesome! Only 2 things that didn’t go in my favor but ohh well, first, the not sealed up, they fill it up with dielectric grease, witch is nice but water can still get to it and 2nd, they never mention the size of the radius to cut so the grommets fit perfectly, the size is 1-1/4 of radius (2-1/2 ‘’ holesaw is perfect)