Xprite LED Tail Lights

I love these lights. They were super easy to install and look great on my car. One of the best cosmetic changes I’ve done to my jeep and would definitely recommend these to anyone with a jeep

These are awesome. Love them. Took my 11 yr old about 15 minutes to install them for me. I had already replaced my stock lights with some generic knock-off LED lights and one of them stopped working within a month. What a waste of money they were. Thought I saved $40, instead I wasted $40 and wasted my time. The wires were already corroded in the connectors and I had to solder on new connectors ith the old ones. These lights in contrast were plug and play. Super easy to install. Don't understand the reason for the resistor, but mounted it also as instructed in the directions. These are just different looking than most other Wrangler tail lights. Clean looking, smoked glass, perfect brightness. Not too bright as LEDs can sometimes be, but not too dim either. Jeep Wrangler tail lights, at least on my 2012 JKU, have four screws visible, but it's actually only the inside set of two which actually hold the tail light in place. It's only day one since installed, but so far I am super happy with the tail lights. Definitely recommend to my fellow Jeep lovers. Spend the money once and do it right. Don't try and cut corners on this one. These lights even have the side LEDs so the

Very easy to install, as expected with the included Adapters for a nice plug and play setup. The smoke lens look great, especially on my black jeep. They do come with a relay and the brackets to mount the relay to also came with the set. The supplied clips aren’t the most secure with holding the bracket to the frame. If you have an aftermarket rear camera and you Previously wired it into the reverse lights, there’s plenty of wire in the adapter to splice into so your camera comes on when you engage reverse. I am currently finishing up my video reviews on all the xprite lights I purchased, along with which wire correlates to the reverse light, vice brake light (trial and error). The only downside (its a small one) is the way you have to mount the supplied bracket that the relay is attached to. The little metal clips will need a little pre-tightening to them to secure the bracket to the frame inside. Overall I’m very pleased with the lights and love the clean look they provide.

Fitment is pretty close, not perfect but works. The tailights look very nice and work well nice upgrade to my 12’ Rubicon

Lights work perfectly! Pretty easy install. Had an issue that the box didnt come with the proper hardware to mount the resistor. Contacted Xprite and they were very helpful and quick about getting me the parts required to install. Highly recommend. No complaints.

I love these. Got them on a black friday deal last year and they've done great.

looks great thanks

About 30 minutes start to finish. No problem at all. Looks great!

Arrived in less that 24hrs. Seem to be good quality. Install was roughly 15 minutes. Plug and play. Read a few reviews where condensation had started, so I put a bead of silicone around the edges of the light before popping it back into place, then trimmed it off so it wasn't visible. They look awesome compared to stock taillights. Almost fully blacked out in daytime when brakes/signals aren't applied. Super bright at night when both running and braking/signaling.

parfait tres beau

Muy buen productor

Super easy to install and every worked perfectly.

Quick delivery easy to install