Husqvarna 532195227 Steering Bushing

Fit great. Tightened my steering.

worked as expected

This is the correct bushing for a 2015 (and presumably prior years) Poulan Pro 19A42 riding mower. The removal of the old one was relatively easy, although after taking the steering wheel and geared nut off the top of the steering shaft, you do need to move the gas tank to make the area most easily accessible. That only involves removing a couple of screws and pulling the tank out and moving it off to the side. Then you can take a flat screwdriver and pop the old bushing out and slide it up the steering shaft and off. The new one slides down the steering shaft and taps into the hole. Be aware that it fits into the hole at an angle, so you need to make sure to position the bushing with the arrow stamped onto the top of it facing forward. Also, it's handy to take something hollow like a piece of pipe that will fit over the shaft and slide down to sit flatly on the top of the bushing, and tap on that to set the bushing. That will ensure the bushing is at the correct angle. ALSO, while you're at it, check the steering shaft down near the bottom, a short distance above the geared nut that fits against the geared plate to control the steering. There is a horizontal hole in the steering shaft that holds a cotter pin, which holds the steering shaft at the proper height to make the geared nut and the plate stay in the right position to control the steering. On my mower this cotter pin was gone, which I didn't realize until after I put the new bushing on. This actually caused a lot of my problem in the first place, which was the steering being too loose. After I replaced the cotter pin and the bushing, it was back to normal. The old bushing was worn and needed to be replaced anyway so I killed 2 birds with one stone on this job.

Product received as advertised. Good product at a good price.

Perfect fit and replaced my worn out bushing. My steering wheel on my Husqvarna YTH22V46 would move around loosely and made it frustrating to operate. This fixed my issue. I do recommend using a pvc or metal pipe to slide over the steering shaft to tap this bushing into place as it is at an angle.

Fast delivery. Perfect fit. Fixed the problem.

This really makes a huge difference in the amount of "slop" or movement in the steering shaft of my mower. It is a little bit of a challenge to remove the old one and install the new one, so take your time. I recommend removing the fuel tank to allow open access to shaft bushing. The old one will most likely break the tabs upon removing, but no big deal. Simply remove steering wheel and loosen fuel tank enough to pull it forward and out of your way. Remove the old bushing, take the new one and slide over steering shaft. Make sure the little arrow on the part is facing forward. Place bushing to where the tabs line up with slots and either push down evenly on the sides to get the tabs to lock into position or from the top, a long piece of PVC pipe or reasonable facsimile that will fit over the shaft and put it down onto the bushing and tape into position with a hammer. This will apply equal pressure all the way around the bushing to prevent breaking the tabs. Once it is seated properly, re-set fuel tank and steering wheel. You will be amazed at the difference it makes!!

Tightened up the slop in my steering column on my lawnmower

Perfect fit for my mower.

Worked good and fixed play in steering shaft. A little hard to snap in place.

Exact part I requested, delivered promptly.

Worked perfect for Craftsman mower

Excellent fit easily installed