White Enamel Touch Up Paint

Good 👍

Definitely for touch ups only as it’s too thick to get a fine finish over larger areas. Consistency is like thick tip-ex and it starts to dry quite quickly so work fast. This is a pure bright white and my heater it turns out is not as white as this - luckily where I needed to touch up was a big stain on the top edge so I just did the whole top panel in this so it matches in. I could have just left it and saved the tenner but it’s nice to sort out little details and keep on top of the home. I hope I don’t get any more damage to my heaters, but if I do, I’d buy this again. I’ve knocked a star off because the brush came away from the lid so I lost the brush handle which was keeping me from getting messy. I just held it with my fingers - messy but it came off with soap and water. I also could have just used a normal little paint brush. Shame though. P.s have a damp cloth handy if you get any drips anywhere - it just wipes away when it’s still wet no problem.

Really simple to use, like brushing on nail varnish. It quickly improved the look of my bath. The colour wasn’t the exact match to the white of my tub - but for a quick fix this is perfect.

I've used this to repair some rusting bath enamel (after using some hammerite kurust), but its really 'gummy' for want of a better description and goes on too thick. As such, its really hard to get a smooth surface. The brush creates streaks if you go over it after the first initial brush stroke and when trying to even out the surface, creating marks. I had to do several coats, sanding down the lumps to get a smooth surface. I will try it again with a bit of white spirit to dilute it and hopefully it might be a bit smoother. The one benefit of this though, is that as I'm repairing enamel on the side of the bath, being so thick means it doesn't easily drip vertically down, which is a useful property in this instance! Still I would prefer a smooth surface and to use a paper towel to catch drips instead. In terms of durability it does bubble up, as it seems the enamel under the bath is still suffering from rust despite it being cured on the exposed parts, though this is more of an issue with the rust itself than this product.

Having read some of the reviews, I was doubtful about using this to repair chips on the edge of an enamel gas hob. I washed down the area, masked the worktop, shook the small pot for about thirty seconds, then brushed on a thin initial layer and left it to dry. It showed an immediate improvement, the colour blended perfectly and another layer of paint dried to a hard, gloss finish. Now, you have to know where the damage was to see any sign of it.

I had previously tried touching up some marks using radiator paint and it was a didsaster. After reading the reviews I tried this and its much better. You might need 2 coats but its far better coverage and stickability. I don't know about heat resistance since i didn't do anything hot, but on a sink, microwave and cooker side panel it has worked well. The only snag is the bottle is breakable and I left it sitting on a washer/dryer which, when it started vibrating, caused it to drop on the floor and smash, leaving white paint everywhere! Difficult to clean off: white spirit is only partially effective. Cellulose thinners are better but a bit iffy to use.

Bought this to try and keep our trusty microwave running.....the inside had developed a few nasty rust patches so, after rubbing down the areas with fine sandpaper I applied a coat to the affected area and watched as the brush marks magically disappeared. A few hours later I applied a second coat, this time covering the whole area of the "well" in the bottom of the cavity to make it look a bit more aesthetically pleasing, again the brush marks all disappeared to leave a super smooth finish. Left it to dry fully overnight and replaced the small wheeled carrier support and glass dish and, 3 weeks on it shows no signs of wearing or marking. One word of caution...it does give off one hell of a stink whilst drying !

I used this on a Bosch washing machine after the delivery guys scratched it I only saw it after they left ! Well I purchased this based on very good reviews and it doesn’t disappoint, just take your time don’t expect to paint deep scratches with one thick coat as you will make a mess with paint runs my advice is use a low tack masking tape adjacent to the touch up area will be applied especially below as this can run if you use the brush that’s attached to the cap just don’t load the little brush up with too much product wipe it off on a piece of kitchen roll if your brush gets loaded up , it’s expensive but it goes a long way I doubt you would use the lot unless you have large areas to touch up , I can highly recommend this I found the colour a very good match .

Très bon produit il tient bien sûr la surface

L'ho acquistato più di 10 anni fa, ora l'ho riacquistato. Funziona davvero. Impedisce alla nostra vasca di perdere acqua intorno allo scarico. Non si scioglie in acqua calda, quindi rimane intatto sott'acqua. Bisogna riapplicarlo di tanto in tanto per mantenere la tenuta. Dura anni nella bottiglia.

Tolles Produkt, da eine schnelle meines Weber Gasgrills am Emailleteil möglich war. Die Trockenzeit betrag 20 Minuten, fertig. Bin sehr zufrieden.

Très bon produit mais attention : il est BRILLANT, ce qui n'est pas spécifié. À part cela, il couvre parfaitement les surfaces.

Super produit pour les retouches verre et émail.