Epoxy Aluminum Putty

Very easy to work into shapes needed for a given repair. Sets up nicely with a good bond to the item being repaired.

Great for quick patch jobs on aluminum boats, I put a half stick of this into a rock gash on my jon boat to get a little more use out of it before I could get it into the welder, and the patch has held so well that I haven’t actually been to the welder yet.Wear gloves when working with the stuff though, it sticks to your hands.

Repaired a 4" gash in my aluminum 1990 Astro Pro bass boat. This stuff blew my mind on how easy and fast it was to use. Only used a 1/4 of the tube, but it's on board just in case. Life and wallet saver for sure. No lie!!!

I brought Star Brite Epoxy for the small leaks I have in my 12' aluminum boat.I thought this product would turn white after drying but instead turned gray. Not a problem tho.I must have read it wrong. But anyways, it is easy to use. "mix small amount only" it starts to dry fast, cut 1/2" of it and mix till conformed consistency, roll snake like form then the part i didn't do first, use a scraper to force into crack use pressure to force this mixture into crack. The leaks in my boat were along the seams in transom and bow.I use my hands the first time to force it in and it looked like crap. So by the time i got to the front I had it down how to do it right. front looks like a professional job.And this stuff is awesome. I put water in the boat and no leaks. This is the stuff to buy ya can go wrong. Little pricy but differently worth it. I have like over 3/4 of the tube left.It didn't take much by the time ya roll snake like out. I rolled about 1/8" size or smaller just wished it turned white since my boat is white. But not no deal breaker.

This stuff is simple to use and very hard once dried. I used it to fill holes from screws and rivets I removed from an aluminum boat. It cured and was hard enough to sand within an hour. Similar to Bondo but much easier to work with.

fantastic product. Worked better than weilding on my heat exchanger/ exaust manifold.

Funcionan bien 👍

Epoxy was easy to mix together but for some reason it wouldn't stick to the aluminum floats on my pontoon boat. Was able to cram some of the epoxy between two pieces of aluminum to try to hold them together the epoxy hardened but didn't stick to either surface of the aluminum. I don't know if maybe I got a bad batch or what, but if this is the norm for this product I would not buy it again because it didn't do what it was supposed to do.

Great product, highly recommended