Open Cell Foam Tape

Worked well for what I did. Used an adhesive on the tape side so it would stick better. That was my personal touch as to what I was doing.

I used this to replace my car AC foam. It’s amazing stuff! I used the extra lat pieces to seal the back door gap. Easy to cut, flexible and sticky part sticks great!!

Been looking for something similar to Nitto EE-1010 for years; it's apparently impossible to get unless you have a commercial relationship with Nitto. This stuff is the closest I've found so far. Slightly firmer, but has nearly the same compressibility (80-90%+). Really great for eliminating rattles and sealing for air leaks.

The foam itself is a bit denser than I expected and seems to be closed-cell, not open-cell, or perhaps it's semi-open-cell or something like that. This turned out great for my use case (acoustics). Also, it doesn't seem to be natural rubber, seems too homogeneous but that's fine with me. The only thing I didn't like is the backing which is a bit hard to remove, so I lost a few cm to unsuccessful peeling. It now remains to be seen if it decays like rubber or lasts over time.

This foam strip is SO versatile and can work for a ton of things. The foam is very pliable and squishy and can be cut and formed to fit anywhere. Got a cabinet that's rattling or slams closed too hard? Cut a piece of this and put it on there. Got an annoying car rattle? Put some of this inside of the panel that is rattling. The weather seal on your house doors coming off leaving a gap? You got it, put some of this there. Don't want your trash can sliding around? Put on some make-shift feet with this stuff. And yes I've also used this to seal a window air unit and that worked great too!

I put this on my window a/c unit last night. The foam itself seems fine, although it’s not rigid. It’s quite soft, which is good for my usage as my window has some nooks and crannies that require a little maneuvering. The backing was SO hard to remove, though! I ended up having to go at the paper with a knife and even that didn’t work super well. Took me about 10 minutes to get it off finally. Adhesion appears to be good so far.

Good, dense foam but the backing is nearly impossible to remove without tearing the foam.

Easy to install and they give you a good amount of it.

This is a good adhesive roll. Nice and thick, easy to apply and does the job well.

This is the nicest one to work with nice and soft

Ça a bien marcher pour moi, aucune infiltration après l'installation du ruban.

Buena calidad y fácil de instalar

أرخص شريط لاصق يباع بسعر أعلى. الأبعاد هي نفس أبعاد شريط النافذة الرخيص